A) Automotive & Engineering Applications:

1. 1) under bonest sound insulation applications
2. 2) Roofing and flooring applications
3. 3) Door trimand storage section applications
4. 4) Seating systems
5. 5) Sealing electrical components, wires, switches and relays
6. 6) D.G. set canpy and Sound Insulation applications

Features :

1. 1) Customized products as per line speed or drying time requirement of customers
2. 2) Compatibility tests on various materials
3. 3) Efficient delivery and inventory management solutions
4. 4) Customized packaging
5. 5) Superior after sales service.
6. 6) Third party testing and approvals
7. 7) Provide applications methods if required by customer

B) HVAC & DUCTING

• Polygel manufactures water and solvent based adhesives in a range of viscosities for a variety of Ducting and Insulation applications.

Features :

1. 1) Customized products as per customers requirement
2. 2) Compatibility tests on various materials
3. 3) Efficient delivery and inventory management solutions
4. 4) Customized packaging
5. 5) Superior after sales service
6. 6) Third party testing and approvals
7. 7) Provide applications methods if required by customer
8. 8) Fast drying & high green strength
9. 9) Good heat & cold resistance

C) Foam Furnishing & Flooring

• Turbofix Adhesives are used in manufacturing of Foam Furnitures & Mattresses, Flooring & Carpetting applications:

Features :

1. 1) Can be used by spray gun and hand brush
2. 2) Wide range of materials can be bonded
3. 3) Eco friendly and meets health and safety regulations.
4. 4) Superior after sales services
5. 5) Third party testing and approvals
6. 6) Provide application methods if required by customers

A) PU Adhesive – or1000 Application

It is preferable to use the adhesive mixed with cross linking agent like Yamadur H-20 / Yamadur R-22 in the ratio of 5% by volume in order to attain better durability of bonded surfaces, resistance to higher service temperature and wider bonding range. The surfaces to be joined, are to be made free from dust, oil and grease. A thin layer of Hardener-added adhesive is to be applied on the surfaces to be bonded. Track-free adhesive films on both substrates are to be heat activated at around 70 degree Centigrade and then pressed together with uniform pressure while hot. Final peel strength will be achieved after 24 hours.

B) HARDNER – r22 Application

1. The adhesive either of natural, synthetic rubber or polyurethane base is to be mixed with the hardener Yamadur R 22. The percentage of cross linking agent to adhesive can vary from 3 to 7% depending on the end use. The mixed adhesive is to be brushed on the roughened surfaces to be bonded. The pot life of the adhesive mix is limited and depends on the type of the adhesive use.

2.For bonding metal with compounded rubber, the metal surface is to be sand blasted or acid etched followed by degreasing with trichloroethylene. Thin and uniform layer of Yamadur H-20 is to be brushed on the clear and dry metal surface. Allow to dry for 20-30 minutes. Lay the compounded unvulcanized rubber on the coated metal and vulcanize the rubber in mould under heat and pressure as required.